3 Setting Up the 850-DS
16 850-DS Operator’s Manual
Initial Setup
Complete the following sections to initially set up the Agilent 850-DS and all other
system components.
1 Prepare an area next to a dissolution apparatus where the Agilent 850-DS will
be placed. The preferred location is on the right side of the dissolution
apparatus.
2 Remove the Agilent 850-DS and all other system components from the
packing material and place on a bench or table.
3 Inspect the equipment and accessories to ensure there has been no damage
during shipment.
4 Orient the Agilent 850-DS and all other system components appropriately.
Height 40 cm (60 cm with Filter Module)
Width 39.0 cm (48.0 cm with filter waste bin)
Depth 60.0 cm
To Next Page
Loading...
