4 Operating the 850-DS
50 850-DS Operator’s Manual
Run Method Screen 2
Figure 22. Method Start Parameters
This screen allows you to enter parameters that are stored with the method run.
These parameters are available on a printout if your unit has the optional printer
installed.
Option Function
Operator 25-character field for operator name entry.
Lot 25-character field for lot information.
Batch 25-character field for batch information.
Note 25-character field for additional notes.
Dissolution
Apparatus Control
Allows the Agilent 850-DS to control a dissolution apparatus.
Note: Enable this option only if the Agilent 850-DS is connected to another
Agilent/Varian/VanKel dissolution apparatus. If connected to a third-party
dissolution apparatus with resident probes, do not check this box.
Instant Start a method instantly.
Vessel Temperature Will start a method once the vessels have achieved a stable temperature as
specified in the method to be run within the temperature tolerance settings of
the 850-DS.
Bath Temperature Will start a method once the bath has achieved a stable temperature as
specified in the method to be run within the temperature tolerance settings of
the 850-DS.
To Next Page
Loading...
Need help?
General
