Agilent Technologies 850-DS - Power Cord; Apparatus Control Cable

3 Setting Up the 850-DS
22 850-DS Operator’s Manual
Power Cord
1 Attach the provided power cord to the back of the instrument.
2 Plug the cord into an electrical outlet of suitable voltage.
Apparatus Control Cable
If connecting to an Agilent, Varian or VanKel dissolution apparatus, connect the
DB25 communications cable from the RS232 port on the right rear of the Agilent
850-DS to the 25-pin port on the rear of the dissolution apparatus.
For 850-DS setup with an online UV Dissolution system, refer to the Operator’s
Manual or the help files in the software for the applicable system.
CAUTION
Ensure the correct voltage has been supplied prior to connecting
the power cables.