3 Setting Up the 850-DS
26 850-DS Operator’s Manual
Downloading screens to the 850-DS firmware
1 Power off the 850-DS.
2 Insert the SD card in the slot at the right front of the instrument and press the
card in fully. You may feel a click as the card seats completely.
3 Power on the 850-DS and wait approximately 2 minutes for the images to
automatically load. When complete, one of the Main screen images will
display on the screen.
4 Power off the 850-DS, wait 30 seconds, and then power it on again. The
update is now complete and the 850-DS should start normally.
To Next Page
Loading...
Need help?
General
