1b-42
Operation Reference
Function
5. DEL
Press
DEL and a register number (00 through 99) to delete that register. The specified
register is deleted from the currently selected sequence only, but registers in other
sequences you have set up are not affected. After you have deleted a register, you will not
be able to recall that register number until you have saved operating settings in it again.
NOTE The register number is immediately deleted from the sequence when the
delete entry is completed. However, the settings contained in the register are
recalled when you delete the register so you can re-save the settings if you
need to.
Renumbering the Registers If you use the arrow keys to recall the registers in
sequence, the deleted register number will be skipped. If you wish to eliminate the skip,
you can do so by moving each register following the deleted register back one register
number. To delete an entire sequence, delete each register in the sequence.
To Next Page
Loading...
Need help?
General
