1-106
Making Measurements
Using Test Sequencing
1. To view the first six sequences on the disk, press:
• If the desired sequence is not among the first six files, press:
until the desired file name appears.
2. Press the softkey next to the title of the desired sequence. The disk access light should illuminate briefly.
NOTE If you know the title of the desired sequence, you can title the sequence (1–6) with the
name, and load the sequence. This is also how you can control the sequence number of an
imported titled sequence.
Purging a Sequence from Disk
1. To view the contents of the disk (six titles at a time), press:
• If the desired sequence is not among the first six files, press:
until the desired file name appears.
2. Press the softkey next to the title of the desired sequence. The disk access light should illuminate briefly.
Printing a Sequence
1. Configure a compatible printer to the analyzer. (Refer to the “Options and Accessories” chapter of the
reference guide.)
2. To print a sequence, press:
and the softkey for the desired sequence.
NOTE If the sequence is on a disk, load the sequence (as described in a previous procedure) and
then follow the printing sequence.
In-Depth Sequencing Information
Features That Operate Differently When Executed in a Sequence
The analyzer does not allow you to use the following keys in a sequence:
and keys
key, and
(backspace key)
To Next Page
Loading...
Need help?
General
