4- 43
Printing, Plotting, and Saving Measurement Results
Saving Measurement Results
How the Analyzer Names These Files Sequentially
When text files are saved, the analyzer generates the file names automatically in the following format:
txtcss.csv
where: txt is a constant that indicates that this is a text file,
c is the indicator of the channel (14) on which the measurement data was taken.
ss is a 2-digit, sequential indicator of the measurement (file index number). The file index
number may be numbered from 0031. As the next measurement is taken, the file index
number is incremented.
If all four channels are making measurements and a save is performed, there will be four
channel numbers that share the same file index number. For example, the files would be
named txt100.csv, txt200.csv, txt300.csv, and txt400.csv. If a measurement does not include
all four channels, unused channel-file index numbers will not be used by the next
measurement. However, if all of the files that share a file index number are erased, that file
index number will be re-used.
csv is the file format, comma-separated value in this case.
To Next Page
Loading...
Need help?
General
