4 Basic Operation
Setting Up and Running a Single Sample
Agilent Triple Quadrupole LC/MS System User Guide 80
Setting Up and Running a Single Sample
1 Click the Sample Run window.
2 Enter the Sample Name, the Data File Name and Path, and other values.
3 Optional. Enter the Additional Information. If needed, change the value of the
parameters in the Additional Information list.
Run a Data Analysis method from this window by selecting Both Acquisition
and DA or Acquisition Only for the Part of Method to run.
If using Both Acquisition and DA Part of Method to run, the Override DA method
is required.
4 To start the single sample run, click Run in the Sample Run window toolbar.
To Next Page
Loading...
Need help?
General
