103
REPLACEMENT OF MAIN COMPONENTS
4) Mount the intake manifold with 6 bolts.
NOTE) Replace the gasket before mounting the
intake manifold.
5) Mount the blow-by hose and tighten the bolt.
6. Connect the air intake hose and the oil hose to the
engine.
7. Mount the surrounding parts of exhaust air heat
exchanger.
1) Mount the stay and tighten 4 nuts.
2) Mount the exhaust pipe. Tighten it with 2 nuts and
2 bolts.
NOTE)
Replace the gasket before mounting the exhaust
pipe.
The outdoor unit has the deodorizing catalyst
instead of the exhaust pipe if the deodorant kit is
installed.
Bolts (6 pieces)
Bolts
Tightening torque 6.3 lb·ft (8.5 N·m)
Oil hose
Air intake hose
Nuts
Tightening torque 14.8 lb·ft (20.0 N·m)
Exhaust pipe
Nuts
Bolts
Tightening torque 14.8 lb·ft (20.0 N·m)
To Next Page
Loading...