102
REPLACEMENT OF MAIN COMPONENTS
4) Apply engine oil to the both ends of the 6 push rods,
and install them in the order of removal.
5) Mount the 6 valve stem caps on the valve.
6) Mount the rocker shaft so that the adjustment
screws come into the cup of the push rods, and
tighten 3 nuts.
NOTE) Take care not to drop the valve stem cap into
the engine.
4. Pour engine oil on the rocker arm portion evenly.
5. Mount the surrounding parts on the cylinder head.
1) Attach the cylinder head cover with 3 nuts.
NOTE) Wipe off the oil on the sealing surface before
mounting the cylinder head.
2) Mount the 2 stays with 4 bolts.
3) Mount the 3 ignition coils with 3 bolts (3 places).
Valve stem cap
Valve
Rocker shaft
Nuts
Push rods
Tightening torque 14.8 lb·ft (20.0 N·m)
Cylinder head cover
Nuts
Bolts
Bolts
Bolts
To Next Page
Loading...