105
REPLACEMENT OF MAIN COMPONENTS
4) Check the engine coolant level in the reserve tank,
and refill the engine coolant until the engine coolant
reaches the reference line.
5) Run the engine coolant pump using check mode
"engine coolant refill mode (code No. OA)" of the
board maintenance functions.
6) Check the engine coolant level in the radiator. If the
level is low, refill the engine coolant until the engine
coolant level reaches the full level.
7) Repeat items 5) and 6) until the engine coolant level in the radiator does not lower any more, and close the cap.
8) Check the engine coolant level in the reserve tank, and refill the engine coolant until the engine coolant reach-
es the reference line.
14. Using a compression gauge, check that fuel gas is compressed to the specified pressure.
15. Run the engine and check that the engine runs without problems such as leakage of oil or engine coolant.
Reference line
Reserve tank
Specified compression value 203 psi (1.4 MPa) or higher
Compression limit 160 psi (1.1 MPa)
To Next Page
Loading...