249
TROUBLESHOOTING
01
Re-wiring
recognition
setting
Command mode, check mode
Indoor / outdoor unit re-wiring recognition is set.
Only indoor unit re-wiring recognition during automatic address setting is available in command
mode.
Example) Method of indoor unit re-wiring recognition setting
Select command (Initial display)
Indoor unit re-wiring recognition Outdoor unit re-wiring recognition
Switching with [INDOOR UNIT] switch
→
←
↓
Press [SET] switch for 0.5 seconds
During command setting
※ [CLEAR] switch enables the system to proceed to command selection.
↓
Press [SET] switch for 2 seconds
Return to select command (setting is completed)
Re-wiring recognition setting process is completed
"End" display disappears by changing the
command to another one or switching indoor/
outdoor unit.
※ After re-wiring recognition, the system conducts automatic address of indoor/outdoor units
again as when the power is turned ON.
Code No. /
functions
Operational procedure / display contents
To Next Page
Loading...