281
TROUBLESHOOTING
7b
Periodical
inspection
Monitor mode
Displays periodical inspection status.
Before periodical inspection time
Remaining time until next periodical inspection is
displayed
(In this case, periodical inspection alert will be sent
1,134 hours later.)
On or after periodical inspection time
"oVEr" is displayed
Check mode
Reset periodical inspection
Select command (Initial display) Displays the periodical inspection status
OR
↓
Press and hold [SET] switch (for 0.5 seconds)
During command setting
↓
Press and hold [SET] switch (for 2 seconds)
Return to select command (setting is completed)
Periodical inspection reset Completed
Reset is completed.
"End"display disappears when other command is
selected
Code No. /
functions
Operational procedure / display contents
To Next Page
Loading...