284
TROUBLESHOOTING
Code No. /
functions
Operational procedure / display contents
9d
Heating hot
start high
pressure
value
Monitor mode
Displays heating hot start high pressure value. (display range : 1.00 ~ 3.50 MPa)
When heating hot start high pressure value is 2.86 MPa
When heating hot start high pressure value is not set
※ Pressure is shown in MPa. To convert it to psi, use the following formula. psi = MPa x 145.04
b0~b9
Error log
(latest ~ 9
times ago)
Monitor mode
Displays error log.
In the case of error log 2 (previous)
Alternately displayed
→
←
※ Code number table (excerpt from the code number list)
Code No. Error log contents
b0 Error log 1 (latest)
b1 Error log 2 (previous)
b2 Error log 3 (2 times ago)
b3 Error log 4 (3 times ago)
b4 Error log 5 (4 times ago)
b5 Error log 6 (5 times ago)
b6 Error log 7 (6 times ago)
b7 Error log 8 (7 times ago)
b8 Error log 9 (8 times ago)
b9 Error log 10 (9 times ago)
Monitor code
Engine running hours when
an error occurred (10 hours)
Error main code
Error sub code
To Next Page
Loading...