AISIN SEIKI E1 Series - Page 285

283
TROUBLESHOOTING
Code No. /
functions
Operational procedure / display contents
98
Tc set value
99
Te set
value
9c
Heating
indoor SC
target set
value
Monitor mode
Displays Tc set value (code No. 98) / Te set value (code No. 99) / heating indoor SC target set value
(code No. 9c). (display range : -20 ~ 60 ℃ )
When Tc set value is -1 ℃
When heating indoor SC target set value is 12 ℃
When heating indoor SC target set value is not set
※ Temperature is shown in Celsius (C). To convert it to Fahrenheit (F), use the following formula.
F = C x 9/5 + 32
9A
Electronic
expansion
valve open
position of
the indoor
unit whose
is stopped
in heating
mode
9b
Electronic
expansion
valve open
position of
the indoor
unit whose
tempera-
ture control
is stopped
in heating
mode
Monitor mode
Displays electronic expansion valve open position of the indoor unit whose is stopped in heating
mode (code No. 9A) / electronic expansion valve open position of the indoor unit whose temperature
control is stopped in heating mode (code No. 9b). (display range : 0 ~ 250 step)
When electronic expansion valve open position of the indoor unit whose is stopped in heating
mode is set at 110 steps
When electronic expansion valve open position of the indoor unit whose temperature control is
stopped in heating mode is set at 140 steps
When electronic expansion valve open position of the indoor unit whose temperature control is
stopped in heating mode is not set