73
REPLACEMENT OF MAIN COMPONENTS
[Reassembling]
1. Unscrew 6 bolts from the new engine to remove the
flywheel.
NOTE) Once removed, the bolts can not be reused.
Put on the shelf these bolts.
2. Mount the surrounding parts on the new engine.
1) Mount the exhaust manifold and tighten 6 nuts.
NOTE) Replace the gasket before mounting the
exhaust manifold.
2) Mount the gas mixer and tighten 2 bolts.
NOTE) Replace the gasket before installing the gas
mixer.
3) Mount the blow-by hose and tighten the bolt.
Bolts (6 pieces)
Nuts (6 pieces)
Tightening torque 14.8 lb·ft (20.0 N·m)
Gas mixer
Bolts
Tightening torque 14.8 lb·ft (20.0 N·m)
Blow-by hose
Bolt
Tightening torque 6.3 lb·ft (8.5 N·m)
To Next Page
Loading...