76
REPLACEMENT OF MAIN COMPONENTS
8) Mount the front side bracket and tighten 5 bolts
in the order shown right.
9) Remove the 3 wooden blocks under the compres-
sor bracket and oil pan.
4. Reassemble the exhaust water drain filter box.
1) Mount the box and tighten 2 bolts.
2) Connect the 3 exhaust water drain hoses to the
box.
3) Mount the stay and tighten 2 bolts.
NOTE) Connect the connector of the exhaust water
drain filter if the drain heater kit is installed.
5. Connect the air intake hose and the fuel gas hose
to the engine.
①
②
③
④
⑤
Front side
①② Tightening torque 14.8 lb·ft (20.0 N·m)
③～⑤ Tightening torque 31.0 lb·ft (42.0 N·m)
Exhaust water drain hoses
Bolts
Tightening torque 14.8 lb·ft (20.0 N·m)
Bolts
Tightening torque
3.7 ± 1.1 lb·ft
(5.0 ± 1.5 N·m)
Heater
Air intake hose
Fuel gas hose
To Next Page
Loading...