82
REPLACEMENT OF MAIN COMPONENTS
[ 15 TON ]
[Removal]
1. Drain engine oil.
1) Clamp the oil hose with 2 hose clippers at both
sides of joint.
2) Disconnect the joint and drain oil from the engine
and the sub oil reservoir.
3) Disconnect the 3 oil hoses from the engine.
NOTE) Be careful because oil will drip from the oil
hoses when you remove the hoses.
2. Drain engine coolant.
1) Clamp the engine coolant hoses at the outlet
and inlet ports of the radiator (2 places) with 2 hose
clippers.
2) Open the radiator cap.
3) Clamp the oil hose with 2 hose clippers at both
sides of joint.
4) Remove the joint, and loosen one hose clipper at
a time to drain engine coolant of both sides.
Sub oil reservoir
Clamping positions
Oil hoses
Oil hose
Joint
Clamping positions
Radiator cap
Engine coolant pump
Joint
Clamping positions
Pump outlet side
To Next Page
Loading...