www.aja.com
22
FS4 Frame Synchronizer/Converter v1.1
Channel Select Buttons
VID1-4 Selects which Video Processor the nine VIDEO buttons will access menus for control. In
Single Channel Mode any button can be pressed.
Blue = A valid video source is present.
Red = An invalid video source is detected (unless the alarm has been suppressed, in
which case the LED will be turned off).
Off = No video is present, or invalid video is detected and the alarm is suppressed.
NOTE: The FS4 operating mode can be determined by the VID 1-4 button tallies. In Four Channel
Mode all four LEDs light, with the selected Video Processor high tally. In Single Channel Mode
only the VID1 button tally is low tally or high tally.
EMBED Selects Embedded Audio for control by menus accessed by the three AUDIO Menu Group
buttons.
Blue = Valid embedded audio is present on any video source.
Off = No embedded audio is detected.
AES Selects AES and MADI for control by menus accessed by the three AUDIO Menu Group
buttons.
Blue = Valid AES or MADI audio is present.
Off = No AES or MADI audio is detected.
Video Menu Group Buttons
INPUT •Input source selections
• Loss of input selection
•Reverse Telecine
• Input scan format settings (PsF or interlaced)
• Input Image Mapping (Four Channel Mode only)
ANC • Active Format Descriptor (AFD) settings
• Caption translation selection
• SD line 21 blanking selection
COLOR • Proc amp and color corrector
• Legalizer settings
FORMAT • Output format
• Link Configuration
•SD Aspect Ratio
• Up and Down Convert settings
• Output Image Mapping (Single Channel Mode only)
SCALE • Custom Size and Position and ROI settings
KEYER • Background fill selection
•Sidebar Edge
• Matte adjustments
TIMING • H and V timing and delay settings
To Next Page
Loading...
