www.aja.com
30
FS4 Frame Synchronizer/Converter v1.1
Networking Using
DHCP or Default
Static IP
The FS4 factory default configuration automatically looks for a DHCP server to issue an IP
address. If your network includes a DHCP server, plug the FS4 into the network and
connect with the unit as follows:
1. Press the CONFIG button.
2. Turn the SELECT knob to navigate to config parameter 3.2. Note on a piece of paper
the DHCP-supplied IP address shown.
3. With your laptop or desktop computer connected to the same LAN as the FS4 and
DHCP enabled, launch a web browser, type the IP address you noted on the FS4's
display into the browser address field and press Enter. You should now see the FS4’s
browser Status screen.
If the FS4 cannot get an IP address from the network DHCP server, the FS4 will
automatically use a preset factory static IP address of 192.168.0.2. You can access the FS4
using the default static address as follows:
1. Set your computer's IP address to whatever address you prefer in the 192.168.0 (class
C) network.
2. Set the computer’s Subnet mask to 255.255.255.0 (most PCs default to the proper
netmask when the address is set).
3. Set the gateway address, if used, to match the FS4 default: 192.168.0.1. Alternatively,
change the FS4 gateway address to match your gateway:
A. Press CONFIG, turn SELECT to 3.4 Default Gateway, push and then turn ADJUST to
change the first group of digits.
B. Turn SELECT to advance to the next set of numbers, and turn ADJUST to set these
numbers.
C. Continue using SELECT and ADJUST to set the full address.
D. When finished, push ADJUST momentarily to save the address.
4. Run a browser on the computer and type “192.168.0.2” (the factory static IP address).
You should now see the FS4’s browser status screen.
When you can access the FS4 screens, see “Browser Remote Control” on page 88 for details
about configuring the FS4 using a browser.
Networking the FS4
Using Your Own
Static IP
If you don’t want to use DHCP or the default static IP address, you can set your own static
IP address:
1. Select the CONFIG button and use the SELECT knob to navigate to parameter 2.1 IP
CONFIG. Use the ADJUST knob to select Static.
2. Turn SELECT to navigate to parameter 3.2 IP ADDRESS. The display shows the default
static IP address: 192.168.0.2.
3. Change the IP address as follows.
A. Push the ADJUST knob momentarily so that the first octet (set of numbers) blinks,
and then turn ADJUST to change the numbers.
B. Turn SELECT to advance to the next set of numbers, and turn ADJUST to set these
numbers.
C. Continue using SELECT and ADJUST to set the full address.
D. When finished, push ADJUST momentarily to save the address.
4. Turn SELECT to advance to 3.3 Subnet Mask. Use the SELECT and ADJUST knobs as in
the previous step to set the desired subnet mask.
To Next Page
Loading...
