www.aja.com
67
FS4 Frame Synchronizer/Converter v1.1
may have been edited) that same approximately 10 frame interval is required after the
discontinuity to detect and process the new cadence pattern.
4 Input Scan Format This parameter determines how the Deinterlacer handles interlaced vs. PsF inputs.
Normally, this control will only be used to indicate that a 1080PsF25 input is PsF and not
interlaced.
Auto When Auto is selected, the system will look for clues in the source's SMPTE 352 (Payload
ID) data and respond accordingly. If there is no SMPTE 352 information, the system will
assume that 23.98/24 fps sources are PsF, and 25/29.97/30 fps sources are interlaced.
Progressive When Progressive is selected, the system will assume that all sources are PsF (even if
there is SMPTE 352 data to the contrary).
Interlaced When Interlaced is selected, the system will assume that all sources are interlaced (even if
there is SMPTE 352 data to the contrary)
Auto (default) Deinterlacer detects input source payload ID data and sets the
processing format accordingly.
Progressive Assumes all input sources are progressive.
Interlaced Assumes all input sources are interlaced.
To Next Page
Loading...
