157
To play a slice, do either of the following:
• Press the pad that corresponds to the slice. If your sample has more than 16 slices, use the
additional pad banks.
• When the headphones icon (in the upper-right corner) is selected, tap your finger on a slice in the
waveform.
When the One Shot feature is enabled, you can press a pad once to play the entire slice. When this is
disabled, pressing the pad and holding it will play the slice; releasing it will stop playback.
To enable or disable One Shot, press and hold Shift, and then tap One Shot.
To select a slice to edit, do either of the following:
• Use the Slice field.
• Turn the top-most Q-Link Knob in the fourth bank.
• When the headphones icon (in the upper-right corner) is selected, tap your finger on a slice in the
waveform.
To add a slice at the current playhead position, tap Slice+ at the bottom edge of the touchscreen.
You can do this at any point during sample playback.
To split or combine slices, tap the glue-and-scissors
icon.
In the Split/Combine Region window that appears, tap
one of the following buttons:
• Split: This splits the currently selected region into
two equal slices.
• Combine: This combines the currently selected
region with the one before it.
• Back: This closes the window.
To Next Page
Loading...
