180
To record using the Sampler:
1. Make sure to reduce the volume levels of your audio source and speakers/headphones/monitors
before you make any connections to avoid “pops” or feedback.
2. Connect a microphone, audio player, etc. to the input(s) of your MPC Touch.
3. Turn the Rec Gain knob to set the input level while speaking into the microphone. You should now
see the level in the meter. Make sure it does not exceed the maximum level (the meter should not be
“peaking” constantly).
4. Set the recording controls as desired (described in this chapter).
5. Tap the Arm button to record-arm the Sampler.
6. Speak/sing into the microphone or play your audio source. The Sampler will start recording
immediately when the input level reaches the threshold value. Alternatively, tap the round Record
button to manually start recording.
Tip: You can record a sample while playing a sequence.
7. To stop recording, tap the round Stop button. Use the options in the Keep or Discard Sample
window that appears to continue.
To Next Page
Loading...
