76
When you edit an effect, you will see this window:
In this window:
• To adjust a parameter, tap and drag its slider. Alternatively, use the Data Dial or –/+ buttons. To
make finer adjustments, double-tap the pad and adjust the larger version of the slider that appears.
Tip: Turn the Q-Link Knobs to quickly adjust the corresponding 4 parameters. Use the Q-Link
button to select another set of 4 parameters the Q-Link Knobs control.
• To select another page of parameters, tap the Parameters –/+ buttons at the top of the
touchscreen.
• To enable or disable the effect, tap the On/Off button in the upper-right corner.
• To edit parameters for another insert effect on the same pad, program, etc., tap a different
Insert tab at the bottom edge of the touchscreen to select it.
• To close the window, tap Close or the upper part of the touchscreen.
To Next Page
Loading...
