X4IP, X8PL, and X5IP option card test
...................................................................................................................................................................................................................................
Overview
This test verifies that the Ethernet option card under test is properly installed and that
it functions correctly. In case of a DDF, the connections are tested by generating a port
alarm. This procedure applies to the X4IP, the X8PL, and the X5IP Ethernet option
cards.
Estimated duration
10 minutes.
Start condition
Make sure the following start conditions are fulfilled:
• The procedure in section “Preparation and test of the main unit” (p. 7-6) must have
been performed and the test results are correct.
• The ITM-CIT must be connected and logged-in to the NE.
• Ethernet Ports in Auto Negotiation Mode:
Enabled (Default).
Procedure
Proceed as follows to perform the X4IP, X8PL, and X5IP option card test:
...................................................................................................................................................................................................
1
Assign the installed option card.
...................................................................................................................................................................................................
2
Set the alarm LANcNES (LAN Not Expected Input Signal) to “Reported”.
...................................................................................................................................................................................................
3
Connect LAN2.1 to LAN2.2 using CAT5 crossed UTP Ethernet cables.
...................................................................................................................................................................................................
4
Check on the alarm list, and verify that the requirements mentioned in the table below
are met.
Result:
Requirements
LEDs on the 1643 AM/AMS:
Power LED: On
Fault LED: Off
Link LEDs of related LAN ports: On (green)
Alarms reported on the ITM-CIT: “LANcNES” reported on LAN2.1 and
LAN2.2
Stand-alone test procedures
...................................................................................................................................................................................................................................
7-22
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007
To Next Page
Loading...
