Alcatel-Lucent 1643 AMS - Page 216

• SHDSL E1 modem power is on.
• Test setup as shown in the figure above.
Note: The X12SHDSL-V2 option card has 12 ports and 16 connectors, meaning that 4
ports are not used. Connectors 1{4, 7{10, and 13{16 are used for SHDSL ports 1{12.
Procedure
Proceed as follows to perform the X12SHDSL-V2 option card test:
...................................................................................................................................................................................................
1
Assign the installed option card.
...................................................................................................................................................................................................
2
Verify that the requirements mentioned in the table below are met.
Result:
Requirements
LEDs on the 1643 AM/AMS:
Power LED: On
Fault LED: Off
Alarms reported on the ITM-CIT: No alarms
Conclusion: If the Fault LED is OFF, then the option card is accepted and the
option card software is correctly loaded.
...................................................................................................................................................................................................
3
Set the transport mode of the X12SHDSL-V2 option card. For connecting an E1
modem, select “SHDSL Transport Mode E1” (Go to menu: Provisioning, Transmission,
SHDSL, Transport Mode, select Slot TS2, press EDIT, select the correct Transport
Mode, OK, CLOSE).
...................................................................................................................................................................................................
4
Set SHDSL tributary port TP2.1 to “Monitored”.
...................................................................................................................................................................................................
5
Connect an E1 modem with an SHDSL cable to TP2.1 or to the related port on the
DDF.
...................................................................................................................................................................................................
6
After a while, an NTU_NDD alarm will raise, indicating a new modem has been
detected. Select “Synchronise” from the “NTU (QD2) Node Information” window to
align the MIB with this new device.
...................................................................................................................................................................................................
7
Wait until all alarms are cleared.
Stand-alone test procedures X12SHDSL-V2 option card test
...................................................................................................................................................................................................................................
7-26
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007