Alcatel-Lucent 1643 AMS

To Next Page

To Previous Page

Remote login test

...................................................................................................................................................................................................................................

Overview

This test checks whether the management communication channel via the DCC bytes is

operational on the link.

Estimated duration

5 minutes.

Test setup

Establish a test setup similar to Figure 8-1, “Remote login test” (p. 8-4) .

Be sure that the MS DCC on the line ports of both nodes is set to

Enabled. For the

1643 AM/AMS node this is default.

(Go to menu: Management, Overlay Comms Network, DCC, select

LP1.1 MS, EDIT)

Remark: Node A is expected to be a 1643 AM/AMS node.

Procedure

Proceed as follows to test the DCC communication:

...................................................................................................................................................................................................

With the ITM-CIT login to node A.

...................................................................................................................................................................................................

Check whether you can see the remote node B on the DCC Neighbor list.

(Go to menu: File, NE Login, DCC Neighbors List, click OK.)

...................................................................................................................................................................................................

Do a remote login to node B, and watch the name of node B appear on top of the

ITM-CIT window. (Select

LPx.1, click Login, OK)

Figure 8-1 Remote login test

Link testing

8-4

Alcatel-Lucent - Proprietary

See notice on first page

365-312-802R7.2

Issue 4, June 2007

Main Page

Alcatel-Lucent 1643 AMS - Page 224

Table of Contents

Other manuals for Alcatel-Lucent 1643 AMS