Alcatel-Lucent AOS-W 6.5.3.x - Page 960

960| Voice and Video AOS-W 6.5.3.x| User Guide
1. Navigate to the Configuration > ADVANCED SERVICES > All Profiles page of the switch WebUI.
2. In the Profiles section, expand Controller and click Mgmt Config.
The Profile Details section displays a list of management configuration profiles in the switch.
To add AMP as a management server in the switch:
1. Navigate to the Configuration >MANAGEMENT> General page of the switch WebUI.
2. In the AirWave Servers section, click New.
3. In the Primary Server text-box, enter the primary OmniVista server IP.
4. From the Profile List drop-down list, choose the default-amp profile.
5. Click Add and Apply.
In the CLI
Execute the following command in the switch CLI to view the default AMP management server profile:
(host) #show mgmt-server profile
Mgmt Config profile List
------------------------
Name References Profile Status
---- ---------- --------------
default-ale 0 Predefined (editable)
default-amp 0 Predefined (changed)
Total:2
Execute the following command in the switch CLI to add AMP as a management server in the switch:
(host)(config) #mgmt-server type amp primary-server <primary-server-ip> profile default-amp
Enabling UCC Monitoring in the Switch
By default, UCC Monitoring is disabled in the switch. You can enable this setting using the switch WebUI or
CLI.
In the WebUI
To enable UCC Monitoring in the switch:
1. Navigate to the Configuration > ADVANCED SERVICES > All Profiles page of the switch WebUI.
2. In the Profiles section, expand Controller and click Mgmt Config.
The Profile Details section displays a list of management configuration profiles in the switch.
3. Click an instance of the management configuration profile.
4. In the Profile Details section, check the UCC Monitoring check box.
5. Click Apply.
In the CLI
Execute the following command in the switch CLI to enable UCC Monitoring:
(host)(config) #mgmt-server profile default-amp
(host)(Mgmt Config profile “default-amp”)#uccmonitoring-enable
Verifying the Configuration
Execute the following command in the switch CLI to view the management server configuration profile:
(host) #show mgmt-server profile default-amp
Mgmt Config profile "default-amp" (Predefined (changed))
--------------------------------------------------------