Alcatel-Lucent AOS-W 6.5.3.x - Page 959

n Viewing the list of Lync/Skype for Business Clients on page 953
n Viewing UCC Client Information on page 959
n Viewing UCC Configuration on page 959
n Viewing UCC Statistics on page 959
n Viewing UCC Trace Buffer on page 959
Viewing UCC Call Detailed Record
Use the following command to display the CDR statistics for UCC:
(host) #show ucc call-info cdrs [ap | app | cid | detail]
Viewing UCC Client Information
Use the following command to display the UCC client status and CDR statistics:
(host) #show ucc client-info [app | detail | sta]
Viewing UCC Configuration
Use the following command to display the UCC configuration in the switch:
(host) #show ucc configuration [cac-alg | dialplan | logging | midcall-timeout | realtime-
analysis | rtcp-inactivity | sip | traffic-control]
Viewing UCC Statistics
Use the following command to display the UCC call statistics in the switch:
(host) #show ucc statistics {counter | dial-plan | remote | tspec-enforcement |wmm-flow}
Viewing UCC Trace Buffer
Use the following command to display the UCC call message trace buffer for Skype4B, SCCP, and SIP ALGs.
Events such as establishing voice, video, desktop sharing, and file transfer are recorded:
(host) #show ucc trace-buffer {skype4b | sccp | sip}
UCC-OmniVista Integration
The UCC-OmniVista integration provides a multi-switch visibility into the UCC solution across deployments. The
switch sends raw UCC data using Application MONitoring (AMON) periodically. OmniVista Management
Platform (AMP) receives these AMON messages and uses this data to display user-friendly aggregated and per-
client UCC statistics in OmniVista. This helps the administrator to assess the overall health and troubleshoot
UCC deployments in a multi-switch environment. The UCC dashboard is supported in OmniVista 8.0 onwards.
Follow these steps to get UCC data in OmniVista from the switch:
Enabling UCC Data Collection in OmniVista
To enable UCC data collection in the OmniVista WebUI:
1. Navigate to the AMP Setup > General tab of the OmniVista WebUI.
2. In the Additional AMP Services section, change the Enable UCC Data Collection radio button to Yes.
Note: To enable this setting, the switch must run AOS-W 6.4 and above.
Adding AMP as a Management Server in the Switch
You can view and add the default AMP management server profile using the switch WebUI or CLI.
In the WebUI
To view the default AMP management server profile:
AOS-W 6.5.3.x | User Guide Voice and Video | 959