ALTAI C1N - Check Network Access to C1 n Series AP;CPE; Configure C1 n Series AP;CPE via Web-Admin Interface

Altai Technologies Ltd. All rights reserved
C1n Series WIFI AP/CPE Web-admin Configuration Manual
TPS15-003_rev1.3
Figure 3-4 Internet Protocol (TCP/IP) Properties in Windows XP
3.2. Check Access
“ping” utility of Command Prompt is a handy tool to check the access to the C1n
Series AP/CPE.
1. Go to the Command Prompt by typing “cmd” in “Run”.
2. Type command:
ping 192.168.1.222
The C1n Series AP/CPE shall respond to your ping request if C1n Series AP/CPE and
your PC have a correct connection.
NOTE: Using the same PC to ping different C1n Series AP/CPE may cause ping failure.
This is because C1n Series AP/CPE has the same default IP address but different MAC
addresses. You need to type command “arp –d” in Command Prompt to clear ARP
table on PC before each ping.
3.3. Configuration with Web-Admin
The C1n Series AP/CPE can be accessed through a Web Browser, for example,
Internet Explorer (IE).
1 Open an IE session and type the IP address of the C1n Series AP/CPE.
Example: http://192.168.1.222 or https://192.168.1.222, where 192.168.1.222 is
the C1n Series ’s IP address. The default IP Address is 192.168.1.222.