ALTAI C1N - Permanent Secondary Ip

Altai Technologies Ltd. All rights reserved
C1n Series WIFI AP/CPE Web-admin Configuration Manual
TPS15-003_rev1.3
Figure 3-6 Web-admin home Page
3.4. Permanent Secondary IP
C1n Series supports a secondary IP address, which uses the last byte of the Ethernet
MAC address as the last byte of the IP address.
Example:
Device Ethernet MAC address: 00:19:BE:20:03:6E
Factory Default Dynamic Secondary IP Address: 192.168.99.110 (6E (HEX) -> 110 (DEC))
The secondary IP shall use IP address from 192.168.99.5 to 192.168.99.254. The other IP
addresses are reserved. If the last byte of the MAC address matches the reserved IP
addresses, the supported device shall follow the following MAC to IP address
mapping.
Ethernet MAC
address
Reserved Purpose
Replaced MAC
byte
Secondary IP
address
XX:XX:XX:XX:XX:00
Invalid IP
A0
192.168.99.160
XX:XX:XX:XX:XX:01
For gateway
A1
192.168.99.161
XX:XX:XX:XX:XX:02
For operator
computer
A2
192.168.99.162
XX:XX:XX:XX:XX:03
For operator
A3
192.168.99.163