Altai Technologies Ltd. All rights reserved
C1n Series WIFI AP/CPE Web-admin Configuration Manual
TPS15-003_rev1.3
Figure 4-14 Radio0 station mode STA info
MAC Address: Radio0 MAC address.
Auth Mode: Authentication mode configured on C1n Series AP/CPE, the
configuration is required to match with the remote AP.
Unicast Cipher: Unicast cipher mode configured on C1n Series AP/CPE, the
configuration is required to match with the remote AP.
State: Radio0 current state.
4.2.1.2.5. AP Info
User may obtain the associated AP information via StatusInterfaceRadio0 AP
Info. The information includes MAC Address, SSID, SNR (dB), Channel, Max Data Rate,
Throughput AP (Tx/Rx), Data Rate AP (Tx/Rx), and Connected Status.
Figure 4-15 Radio0 station mode AP info
AP MAC Address: MAC address of remote AP.
SSID: SSID information of remote AP.
SNR(dB): Remote AP SNR (Downlink).
Channel: Operating channel of remote AP.
Max DataRate: Maximum data transfer rate between station and remote AP.
Throughput AP(Tx/Rx): Actual throughput between station and remote AP.
Data Rate AP: Actual data transfer rate between station and remote AP.
Connected Status: Whether Radio0 is connected to remote AP.
4.2.1.3. Radio0 Interface Status-Repeater Mode
When Radio0’s work mode is configured to Repeater, C1n Series AP/CPE will be
To Next Page
