Altai Technologies Ltd. All rights reserved
C1n Series WIFI AP/CPE Web-admin Configuration Manual
TPS15-003_rev1.3
Figure 5-9 DHCP Server Mode Setting
If the DHCP Server Mode is set to Server, then the C1n Series CPE/AP will act as a
DHCP server for allocation of IP address to the wireless client associated. The following
procedures show the allocation of the IP address, subnets mask, gateway and DNS
information. And edit the Pool ID 1.
Figure 5-10 DHCP Server - Address Pool Setting
Enable Pool: Enable or Disable Pool
Pool ID: ID of the IP Pool
Start IP Address: Start IP address of the Pool
End IP Address: End IP address of the Pool
DNS1, 2, 3: DNS IP address of the Pool
Default Lease Time: Time to release the IP address to the clients
Configure C1n as DHCP server:
To Next Page
Loading...
