141
Chapter 3 Handling
3
Print results look differ-
ent from what was
expected
If you have moved the
printer after the initial
ink charge, specified
colors may not be pro-
duced (colors may be
mixed) due to vibration
or impacts.
Perform manual head cleaning until
there are no more mixed colors.
Hold down the cleaning button for
more than three seconds to start
head cleaning.
No. 4
Print results are blurry
Print results may be
blurry depending on
the thickness of the
paper being used.
Adjust the misalignment of bidirec-
tional printing.
On the [Printer Utilities] tab, select
[Printer Setting Utility]. When the Print-
erSetting screen is displayed, click
[Printer Adjustment] - [Print Head
Alignment] - [Bi-directional Printing
Adjustment].
See
"Print Head Alignment" on page
136.
-
Left and right sides of
the print result are
blurry.
The shutters on the
platen on the outer side
of the paper are set to
open.
When the shutters on the platen on
the outer side of the paper are set to
open, air current may cause printing
trouble; outer edges of the print
result may become blurry.
Follow the instructions on the label on
the top of the printer, and set the
shutters on the platen.
See
"Shutter Adjustment" on page 40.
No. 4
The print result is mis-
aligned laterally.
Paper is not loaded in
the center.
If the paper is loaded out of the cen-
tral position, print results may be mis-
aligned laterally right after the media
is loaded.
Use the media guide to load the
paper in the central position, or feed
the paper first and then start printing.
-
The paper is close to
the rear edge.
When the paper is close to the rear
edge, the print results may be mis-
aligned laterally or become blurred.
Replace the paper.
-
Trouble Description Recovery method
Image/
Illustra-
tion
To Next Page
Loading...