Cleaning, maintenance and repai
162 KE/KX/KG (RIGID) BAH0089-7 02.2020
12.12.2 Replacing the tension springs of the overload safety device (workshop work)
CAUTION
The overload safety on the tines consists of tension springs that are
under high pretension. It is essential to use appropriate tools to install
and remove the tension sprin You must use the suitable device to
install and remove the tension springs in all cases.
Otherwise, there is a risk of injury.
Additional information via Customer Service / Dealers.
12.13 Checking the upper and lower link pins
Check the upper and lower link pins for visible defects whenever the
implement is coupled, and replace if worn.
12.14 Checking/cleaning/lubricating the ratchet clutch
(specialist workshop)
When used under normal conditions, the ratchet clutch is mainte-
nance-free.
If the clutch engages frequently, open the ratchet clutch, clean it and
lubricate it with special grease (for more information, refer to the
maintenance instructions of the universal joint shaft manufacturer).
Use special grease only:
Agraset 116 or
Agraset 117.
To Next Page
Loading...
Need help?
General
