Settings
118 KE/KX/KG (RIGID) BAH0089-7 02.2020
8.4 Adjusting the wheel mark eradicator (optional)
DANGER
Switch off the tractor PTO shaft, apply the tractor parking brake,
switch off the tractor engine and remove the ignition key.
To prevent damage, the implement must not be put down on the
wheel mark eradicators. Using the recessed grip, secure the wheel
mark eradicators in the topmost position (see Fig. 149).
Complaints shall not be accepted if damage is caused by putting
the implement down on the wheel mark eradicators.
To prevent damage to the wheel mark eradicators, the overload safe-
ty may only be triggered by brief overloads. Permanent activation of
the overload safety leads to increased wear. In this case, proceed as
follows:
reduce the working speed
reduce the working depth
use a coulter that is easy to pull (see Fig. 186, section "Changing
the coulters (workshop work)", Seite 161).
Horizontal adjustment
Adjust the wheel mark eradicator horizontally to
the desired position (Fig. 114/2) and secure it
with the bolts (Fig. 114/1).
Fig. 114
To Next Page
Loading...
Need help?
General
