AM8a Instruction Manual (18-0037) CAUTION/REVISIONS
December 2, 1999 0037-TPG.L_18
ii
When using the padded carrying case for the AM8a (P/N 87-0070C), DO NOT PLACE the power cord
around the side of the AM8a in the manner demonstrated in Figure 1.
Instead, be certain to WIND THE CORD UNDER THE CASING in the area between the feet, as shown in Figure
2.
Failure to follow this procedure could cause deterioration of the cord and increase the possibility of electric
shock.
AM8a
(Top of Casing)
Figure 1 — WRONG Figure 2 — CORRECT
Rear Panel
Bracket
AM8a
(Bottom of Casing)
Record of Revisions
December 1991 Original Issue.
February 1992 General data revision.
August 1992 Software upgrade. General format change and reprint.
January 1993 General data revision.
May 1993 Changed listing fonts. Reformatted. Corrected RX connections.
March 1994 General corrections and additions. Added Test Procedure Guide.
October 1994 Logo change. Test Procedure Guide removed.
May 1995 Added Warranty, Calibration, and Repair info.
August 1996 Added E-Mail Address to logos.
K December 2, 1999 Changed GUARDms value for DTMF/MF ANALYZE 3.
L February 10, 2000 Reformatted entire manual and added MF(R1) note.
To Next Page
Loading...