AMERITECH AM8a - Start Time Emulate; Dly:bgn;Endms; Wink:bgn;Durms; Sf Emulate

AM8a Instruction Manual (18-0037) Emulation Parameters
0037-S03.L_24 February 10, 2000
3-7
3.13 START TIME EMULATE
These parameters are used for programming the timing of the DELAY and WINK START
SIGNALS.
START TIME:
EMULATE :
DLY:BGN/ENDms
100 250
WINK:BGN/DURms
100 250
BGN = 15 to 999 (1ms steps)
END = 100 to 9999 (1ms steps)
BGN = 15 to 999 (1ms steps)
DUR = 50 to 999 (1ms steps)
Alternate:
3.13.1 DLY:BGN/ENDms: This setting controls the DeLaY BeGiN timing. This is the time from
seizure until the DELAY START DIAL signal is sent. The AM8a must be set to
EMULATE and have the AUTOMATIC selection made. The END time is when the DeLaY
signal will be removed.
3.13.2 WINK:BGN/DURms: This setting controls the wink BeGiN timing. This is the time
from seizure until the WINK is sent. The AM8a must be set to EMULATE and have the
AUTOMATIC selection made. The DURation controls how long the wink is on the line.
3.14 SF EMULATE
This menu sets the level and frequency variation of the Single-Frequency (2600Hz) signal that
is used for signaling when the TRUNK TYPE is SF (Refer to 2.4.1).
SF
EMULATE :
LEVELdBm
–10
–40 to 0
(1 dBm steps)
Alternate:
:
FREQ + %hz
0.0
-2 to 2
(.1 % steps)
3.14.1 LEVEL: sets the 2600Hz SF tone from –40 dBm to 0 dBm.
3.14.2 FREQ+%hz: sets the frequency variation of the 2600Hz SF tone from –2% to +2% in
.1 % steps (2548Hz through 2652Hz).