AMERITECH AM8a - Ringing Emulate 1; On;Offms; Ringing Emulate 2

Emulation Parameters (18-0037) AM8a Instruction Manual
February 10, 2000 0037-S03.L_
3-6
3.11 RINGING EMULATE 1
This menu controls the ringing Cadence applied to the line during ring.
RINGING :
EMULATE 1:
ON/OFFms
2000 4000
ON/OFFms
0 0
ON/OFFms
0 0
on = 0 to 5000 (1ms steps)
off = 0 to 9999 (1ms steps)
Alternate:
3.11.1 ON/OFFms: Two additional parameters may be used for custom ring cadence
programming. They allow for programming a sequence of cadences to simulate
custom calling features such as callback queuing or auto call back.
NOTE: If Ringing ON time plus OFF time exceeds 10 seconds, a New Call Reset
will occur.
3.12 RINGING EMULATE 2
RINGING :
EMULATE 2:
VOLTAGEvrms
85
30 to 105 (5v steps)
FREQUENCYhz
20.0
15 to 70 (0.1hz steps)
Alternate:
3.12.1 VOLTAGEvrms: This parameter controls the RMS voltage that is applied during the
ring cycle.
3.12.2 FREQUENCYhz: This parameter controls the frequency of the ringing applied during
the ring cycle.