AMERITECH AM8a - Dly Strt (Delay Start) Analyze; STRT Bgnms(Min;Max); Endms(Min); Wink Strt

AM8a Instruction Manual (18-0037) Analysis Parameters
0037-S04.L_32 February 10, 2000
4-3
4.4 DLY STRT (DELAY START) ANALYZE
When the EXPECTED TYPE of Start Signal is set to dialtone/delay, these parameters control
what is reported as an exception. If dialtone is received, these settings are not used.
DLY STRT:
ANALYZE:
STRT BGNms(min/max)
0 300
0 to 999 (1ms steps)
ENDms(min)
140
0 to 9999 (1ms steps)Alternate:
4.4.1 STRT BGNms(min/max): This is the time from off hook to the DELAY dial START
SIGNAL. If the timing is outside the range, it is flagged as an exception.
4.4.2 ENDms(min): This time must be exceeded in order for the delay signal to be valid. A
delay signal shorter than this time will be flagged as an exception.
4.5 WINK STRT
When the EXPECTED TYPE of Start Signal is set to dialtone/wink, these parameters control
what is reported as an exception. If dialtone is received, these settings are not used.
WINK STRT:
ANALYZE :
WINK BGNms(min)
15
15 to 999 (1ms steps)
DURms(min/max)
140 290
50 to 999 (1ms steps)
Alternate:
4.5.1 WINK BGNms(min): This is the time from off hook to the WINK START SIGNAL. If the
timing exceeds this parameter, it is flagged as an exception.
4.5.2 DURms(min/max): This is the time the wink signal must be present to be valid. A wink
signal less than the minimum (min) time or greater than the maximum (max) time of
this setting will be reported as an exception.