Auto and Manual Dialing (18-0037) AM8a Instruction Manual
February 10, 2000 0037-S05.L_
5-2
Auto Dial
Character
SHIFT-SHIFT
(Red LED)
AM8a
Function
P
W
–
F
U
T
SPACE
1
2
3
4
5
6
7
WAIT DT (Wait for Dial-Tone)
WAIT WINK
WAIT (for 3 seconds)
FLASH
UNBALance (line)
TOGGLE DIAL (TT, MF, DP, TT . . .)
BLANK
Special Auto-Dial Functions
5.2 SELECT AND USE AUTO DIAL SEQUENCE
1. The last Auto dial menu shown in the display determines the dialing sequence to be
used when dialing conditions are met (see 2). If desired, you may first recall a stored
number by pressing [SHIFT] [RECALL] [(location)]. "Location" may be 0 through 9
for a previously stored sequence, or "*" to recall the last number dialed.
2. Select the EVENTS display mode.
3. Press SEIZE to go OFF HOOK.
4. If the AM8a is in AUTO mode, the selected sequence is automatically dialed when
dialtone or the EXPECTED TYPE Start Signal is received.
NOTE: The AUTO ON/OFF time between DTMF or MF digits is set by the DTMF/MF,
EMULATE 2 menu described in sub-section 3.6.1. The characteristics of
pulse digits is set by the PULSE EMULATE menu described in sub-section
3.4.
5.3 MANUAL DIALING
1. If the AM8a is in EVENTS display, but not in AUTO mode, digits will be dialed as
dialed-digit keys are pressed on the front panel. As the keys are pressed, the entered
numbers will be stored in the last-number-dialed (*) location (replacing any digits
from a previous dialing sequence). This number may be used later in an AUTO
sequence, or in step 2, below.
To Next Page
Loading...