Rear Panel Connectors and Switch
TM-F1OP-C1XN-01 1-7
Rear Panel SW1 Switch
The SW1 Programming, Monitoring, and Shutdown Select switch is an
8-position piano DIP switch located on the power supply’s rear panel. See
Figure 1-3. The SW1 switch enables you to choose:
• Resistive programming of output voltage or current limit
• Output voltage and current limit programming scales
• Output voltage and current monitor scales
• Remote shutdown circuit logic
• Over temperature shutdown mode
Table 1-2 shows the functions assigned to each SW1 switch. Factory
defaults are underlined.
Figure 1-3
Programming and Monitoring SW1 Switch
(Switch is shown in factory default configuration)
1 Resistive Programming of Output Voltage
2 Resistive Programming of Output Current
3 Selects Output Voltage Programming Source Range
4 Selects Output Current Limit Programming Source Range
5 Selects Output Voltage Monitor Range
6 Selects Output Current Monitor Range
7 Selects Remote Shutdown Logic
8 Selects Over Temperature Shutdown Reset Mode
TM-F1OP-C1XN-01.book Page 7 Thursday, October 25, 2007 9:04 PM
To Next Page
Loading...
