Ametek Sorensen XFR 1200 Watt Series - Figure 2-12 Connecting Remote Sense Lines

Installation
2-26 TM-F1OP-C1XN-01
5. Turn ON the power supply.
Figure 2-12 shows a sample setup for using remote sensing.
Important: If you operate the power supply with remote sense lines
connected to the load and with either of the positive or negative load lines not
connected, the shutdown circuit will activate, causing the output voltage and
current to fall to zero
If you operate the power supply without remote sense lines or local sense
jumpers in place, the supply will continue to work, but supply regulation will be
degraded and/or erratic; or, the OVP circuit may activate.
Figure 2-12 Connecting Remote Sense Lines
TM-F1OP-C1XN-01.book Page 26 Thursday, October 25, 2007 9:04 PM