Introduction
1-8 TM-F1OP-C1XN-01
Resetting the Switches
Before making any changes to the switch settings, disable the power
supply output by pushing the front panel STANDBY switch to its IN
position. This temporarily shuts down the power supply. The front panel
S/D LED turns on. Then use any small, flat-bladed screwdriver to change
the switch settings.
Any of the eight switches on SW1 is OFF (OPEN) when it has been
flipped up to break contact, ON (CLOSED) when flipped down to close
contact.
Table 1-2
Rear Panel SW1 Switch Assignments
Switch Function Open Closed
SW1-1
1 mA current source for resistive programming
of output voltage
Voltage source
programming
Resistive programming
(0-5 k, 0-10 k)
SW1-2
1 mA current source for resistive programming
of output current limit
Voltage source
programming
Resistive programming
(0-5 k, 0-10 k)
SW1-3
Output voltage programming source range
select 0-5 V (0-5 k) 0-10 V
(0-10 k)
SW1-4
Output current limit programming source range
select 0-5 V (0-5 k) 0-10 V
(0-10 k)
SW1-5 Output voltage monitor range select 0-5 V 0-10 V
SW1-6 Output current monitor range select 0-5 V 0-10 V
SW1-7 Remote shutdown logic select HIGH=OFF HIGH=ON
SW1-8 Over temperature shutdown reset mode select Auto reset
Latch OFF
TM-F1OP-C1XN-01.book Page 8 Thursday, October 25, 2007 9:04 PM
To Next Page
Loading...
