Ametek Sorensen XFR 1200 Watt Series - Connecting Single Loads; Figure 2-7 Single Load with Local Sensing (Default); Figure 2-8 Single Load with Remote Sensing

Installation
2-20 TM-F1OP-C1XN-01
Connecting Single Loads
Figure 2-7 and Figure 2-8 show recommended load and sensing
connections for single loads. Local sense lines shown are default
connections at the rear panel J10 sense connector.
You do not need remote sensing for basic operation of your supply.
However, if you wish to correct any small drops in your load lines, then
use the remote sensing feature. See “Local and Remote Sensing” on
page 2–23 for more information.
Figure 2-7 Single Load with Local Sensing (Default)
Figure 2-8 Single Load with Remote Sensing
TM-F1OP-C1XN-01.book Page 20 Thursday, October 25, 2007 9:04 PM