Remote Operation
4-2 TM-F1OP-C1XN-01
Introduction
The rear panel switches and connector on the power supply allow you to
program the supply with an analog device or to output readback signals.
This section covers the following topics:
• See “Remote Analog Programming of Output Voltage
and Current Limit” on page 4–3 for procedures covering remote
analog programming of output voltage and current limit with 0-5 V
and 0-10 V voltage sources and 0-5 k and 0-10 k resistances.
• See “Remote Monitoring of Output Voltage and Current” on page 4–7
for more about the connector and switch settings for using calibrated
readback signals for output voltage and output current with selectable
0-5 V or 0-10 V scales.
Isolated Programming The 4-channel Isolated (ISOL) Programming
Interface is an internal card which can be ordered as an option. It allows
remote programming and readback of the power supply’s output voltage
and current limit with 0-5 V analog signals at a different voltage potential
relative to the power supply’s output. Contact the manufacturer to order
the ISOL Interface.
Remote Digital Programming You can operate the power supply from
a computer if you have had the GPIB or RS-232 Interface card installed as
an option. Refer to the separate interface manual for all setup and
operation instructions for remote digital programming.
TM-F1OP-C1XN-01.book Page 2 Thursday, October 25, 2007 9:04 PM
To Next Page
Loading...
