Local Operation
3-2 TM-F1OP-C1XN-01
Introduction
Once you have installed the power supply and have connected both the
AC input power and the load as covered in “Installation”, the power
supply is ready to operate in local control mode (that is, operation at the
unit’s front panel).
• See “Standard Operation” on page 3–3
for a brief explanation of
Constant Voltage and Constant Current Mode operation.
• See “Using Over Voltage Protection (OVP)” on page 3–7 to “Over
Temperature Protection (OTP)” on page 3–16 for more about power
supply functions such as OVP, shutdown function, OTP, and using
multiple supplies.
• See “User Diagnostics” on page 5–9
for troubleshooting information
for the operator.
•Turn to “Remote Operation” for descriptions of remote programming
options and remote monitoring of the power supply.
TM-F1OP-C1XN-01.book Page 2 Thursday, October 25, 2007 9:04 PM
To Next Page
Loading...
