Inspection, Cleaning, and Packaging
TM-F1OP-C1XN-01 2-3
Inspection, Cleaning, and Packaging
Initial Inspection
When you first receive your unit, perform a quick physical check.
1. Inspect the unit for scratches and cracks, and for broken switches,
connectors, and displays.
2. Ensure that the packing box contains the AC input cover and strain
relief kit (see Figure 2-2). For 60 V to 600 V models, check that the
box also contains the output cable strain relief (see Figure 2-6). For
all models, the output connector shield is already installed.
3. Have the service technician check the printed circuit board and its
components if you suspect internal damage.
If the unit is damaged, save all packing materials and notify the carrier
immediately. See packing instructions in “Packaging for Shipping or
Storage” on page 2–3.
Periodic Cleaning
No routine servicing of the power supply is required except for periodic
cleaning. Whenever a unit is removed from operation, clean the metal
surfaces with naphtha or an equivalent solvent and the front panel with a
weak solution of soap and water. Use low-pressure compressed air to
blow dust from in and around components on the printed circuit boards.
Packaging for Shipping or Storage
Follow these instructions to prepare the unit for shipping or storage.
1. When returning the unit or sending it to the service center, attach a tag
to the unit stating its model number (available from the front panel
label) and its serial number (available from the rear panel label). Give
the date of purchase and an invoice number, if you have it, as well as
a brief description of the problem.
2. For storage or shipping, repack the power supply in its original
container. If the original container is not available, seal the unit in a
plastic bag and then pack it in a 200 lb. (90 kg) test, corrugated
cardboard carton large enough to allow 2 inches (5 cm) of cushioning
material to surround the unit. Use a material such as foam slabs or
chips.
TM-F1OP-C1XN-01.book Page 3 Thursday, October 25, 2007 9:04 PM
To Next Page
Loading...
