Electrical Specifications
TM-F1OP-C1XN-01 A-5
Temperature Coefficient:
h
Voltage (0.02% of Vmax/°C)
Current (0.03% of Imax/°C)
For Resistive Programming:
Voltage (0.06% of Vmax/°C)
Current (0.06% of Imax/°C)
8mV
9mA
24 mV
18 mA
12 mV
6mA
36 mV
12 mA
20 mV
3.6 mA
60 mV
7.2 mA
30 mV
2.4 mA
90 mV
4.8 mA
60 mV
1.2 mA
180 mV
4.2 mA
120 mV
0.6 mA
360 mV
1.2 mA
OVP Adjustment Range:
(5% to 110% of Vmax)
2-44 V 3-66 V 5-110 V 7.5-165 V 15-330 V 30-660 V
Efficiency:
i
0.83 0.86 0.84 0.84 0.85 0.85
a. Minimum output voltage is <0.15% of rated voltage at zero output setting.
b. Minimum output current is <0.5% of model-rated current at zero output setting, when measured on minimum 10% of
full power load.
c. For input voltage variation over the AC input voltage range, with constant rated load.
d. For 0-100% load variation, with constant nominal line voltage.
e. Current mode noise is measured from 10% to 100% of rated output voltage, full current. For 6 V models, current noise
is measured from 2 V to 6 V, full current.
f. Maximum drift over 30 minutes with constant line, load, and temperature, after power on.
g. Maximum drift over 8 hours with constant line, load, and temperature, after 30-minute warm-up.
h. Change in output per °C change in ambient temperature, with constant line and load.
i. Typical efficiency at 100 Vac input voltage and full output power.
Table A-2
Electrical Specifications for 40 V to 600 V Models
TM-F1OP-C1XN-01.book Page 5 Thursday, October 25, 2007 9:04 PM
To Next Page
Loading...
