Angelo AT 61E - Water Connection

- 8 -
3378702_ATE_inst_GB ENGLISH
GB
Angelo Po recommends contacting specialized personnel or water treatment companies in or-
der to be entirely sure that the supply water requirements are fully met.
In the table, the parameters highlighted in bold are those with respect to which the relevant
system performs better.
Parameters Measured value Type of suggested treatment
Carbonate hardness
Chlorine
Chlorides
Sulphates
>9°f
<0.1 ppm
<10 ppm
<30 ppm
Softening
Carbonate hardness
Chlorine
Chlorides
Sulphates
<9°f
0.1 ÷ 1 ppm
<10 ppm
<30 ppm
Activated charcoal  lter
Carbonate hardness
Chlorine
Chlorides
Sulphates
>3°f
<1 ppm
10 ÷ 100 ppm
30 ÷ 100 ppm
Special resin  lter or reverse osmosis
treatment
Carbonate hardness
Chlorine
Chlorides
Sulphates
>3°f
<10 ppm
>100 ppm
>100 ppm
Reverse osmosis
WATER CONNECTION
Caution - Warning
Make the connection in compliance with the relevant legal requirements, using appropriate
and recommended materials
Important
This appliance is to be installed to comply with the
applicable federal, state, or local plumbing codes
having jurisdiction.
Connect the mains line to the appliance’s connection
pipe
,  tting a shut-o tap (B) to allow the water sup-
ply to be cut o when necessary.
B
Important
Wherever chemicals are used in the water supply system for water sani cation, for example
chloramines or sodium hypochlorite, it is necessary to install a  lter to guarantee their
removal.
Important
Check water pipes and  ttings for corroded parts, they may pollute the water inside the
appliance.
Important
If the water features are such to require a treatment system and the shower launching
accessory is installed in the oven (LDR610 and LDL), the water supplied by the latter must
also be treated.
Important
For the United Kingdom only, also see instructions provided in the enclosure.